enquiry@eledsolutions.com +603 9081 6565 / +6013 366 8233 Mon - Fri: 9am - 6pm

We are eLED

Technical Guide – Converting T8 Florescent to eLED T8

posted July 9, 2012

Technical Guide – Converting T8 Florescent to eLED T8

Installation Guide to install eLED T8

This is a typical Florescent T8 circuit diagram.

Step by Step Guide:-

  1. Plug out the starter. Do not need to do any rewiring.
  2. Bypass the ballast by joining the RED and PURPLE wire a shown below.

Below is what the final circuit diagram should look like after the above steps.